RC-Monster Forums - View Single Post - MMM V3

transtalon · 10.26.2008, 12:19 AM

I actually was running a 25 tooth pinion when my MMM just stopped working.
But it was at least 7 minute of speed runs. I know that wasn't the cause of failure. I hooked up a fan on top of Neu 1515 1.5d and my motor does not get past 120 degrees at all. I am running a Poly RC 6k 25C lipo, this batts are awesome, lots of power and very good in retaining the voltage after a couple of months of not being use. To think about I paid 150.00 for a barely use pack from another forum.

	(#37)
transtalon RC-Monster Carbon Fiber Offline Posts: 93 Join Date: Aug 2008	10.26.2008, 12:19 AM I actually was running a 25 tooth pinion when my MMM just stopped working. But it was at least 7 minute of speed runs. I know that wasn't the cause of failure. I hooked up a fan on top of Neu 1515 1.5d and my motor does not get past 120 degrees at all. I am running a Poly RC 6k 25C lipo, this batts are awesome, lots of power and very good in retaining the voltage after a couple of months of not being use. To think about I paid 150.00 for a barely use pack from another forum.