RC-Monster Forums - View Single Post - Slipper Settings w/ A Fieago 9L, MM, and a ESavage?

rawfuls · 11.10.2008, 02:59 AM

1. Yup, as tight as it can go.
2. Already a flat spot.
3. Tried all the way tight, no go. I might have to try again with my regular batteries, as I was using NiCD on the bench.
4. Before the change, I was running LiPos, like insanely speeding?
5. It's almost like it's glitching, but it's not. (No worries, I have a DX3R w/ 2.4ghz ;)) It's trying to go, but something's binding up, I can't figure it out.
6. I can't say really..... It's attempting to go.
7. Shaft isn't free-spinning, it's spinning the pinion as well.
8. It indeed is spinning.
9. I really didn't wanna pop open the HPI's trannys.... Sigh

	(#3)
rawfuls roofles. Offline Posts: 1,982 Join Date: Oct 2008 Location: Woodland Hills, CA	11.10.2008, 02:59 AM 1. Yup, as tight as it can go. 2. Already a flat spot. 3. Tried all the way tight, no go. I might have to try again with my regular batteries, as I was using NiCD on the bench. 4. Before the change, I was running LiPos, like insanely speeding? 5. It's almost like it's glitching, but it's not. (No worries, I have a DX3R w/ 2.4ghz ;)) It's trying to go, but something's binding up, I can't figure it out. 6. I can't say really..... It's attempting to go. 7. Shaft isn't free-spinning, it's spinning the pinion as well. 8. It indeed is spinning. 9. I really didn't wanna pop open the HPI's trannys.... Sigh