RC-Monster Forums - View Single Post

E-Revonut · 09:18 PM

put the stock arms back on and use some 1/2 offset rims! Dramatically improves handling! I have only managed to break one new driveshaft on my E-REVO. That was on the stock rims and talons running 6s. I made a driveshaft out of all the used pieces I have from my previous trucks but snapped that on 5s when I was doing a cartwheel and kept punching it trying to pull out of the cartwheel, but it was the same shaft that was made up of used parts so I don't know if it was already damaged.

Also it has been pretty well documented on here that the stock sliders will hold up to pretty much anything a metal one will.

	(#3)
E-Revonut RC-Monster RC8T Offline Posts: 2,554 Join Date: Jan 2008 Location: Syracuse, New York (Camillus)	11.25.2008, 09:16 PM put the stock arms back on and use some 1/2 offset rims! Dramatically improves handling! I have only managed to break one new driveshaft on my E-REVO. That was on the stock rims and talons running 6s. I made a driveshaft out of all the used pieces I have from my previous trucks but snapped that on 5s when I was doing a cartwheel and kept punching it trying to pull out of the cartwheel, but it was the same shaft that was made up of used parts so I don't know if it was already damaged. Also it has been pretty well documented on here that the stock sliders will hold up to pretty much anything a metal one will. RC-Monster RC8T 1515 2.5D/MMM/5s RC-M 4500mah SC10 MMPro 13.5T 2s NeuEnery 5000mah RC18T Mamba 25/5400kv 2s lipo + 6s NiMh Last edited by E-Revonut; 11.25.2008 at 09:18 PM.