RC-Monster Forums - View Single Post

killajb · 12:45 PM

I sort of took the route that Redshift did.. and had an idea for a dream basher and just went for it. Converted Revo 3.3, Tekno conversion, 1515 2.5D, RPM arms, Vantage chassis, Robinson Racing fwd only diff gears, OEMRC esc with Sportbec BEC, ACE servos and huge 7"wheels.

Despite all of my brushless conversions (4 now), I cannot state how fun this one has been. I usually run on 6s and the esc never even warms up. Once I get some steel CVDs I may try up to 10s and see what happens. As of now, I notice the center to rear plastic drive shaft shows signs of being twisted.

	(#20)
killajb RC-Monster Carbon Fiber Offline Posts: 247 Join Date: Dec 2007	12.02.2008, 12:44 PM I sort of took the route that Redshift did.. and had an idea for a dream basher and just went for it. Converted Revo 3.3, Tekno conversion, 1515 2.5D, RPM arms, Vantage chassis, Robinson Racing fwd only diff gears, OEMRC esc with Sportbec BEC, ACE servos and huge 7"wheels. Despite all of my brushless conversions (4 now), I cannot state how fun this one has been. I usually run on 6s and the esc never even warms up. Once I get some steel CVDs I may try up to 10s and see what happens. As of now, I notice the center to rear plastic drive shaft shows signs of being twisted. Attached Thumbnails Last edited by killajb; 12.02.2008 at 12:45 PM.