RC-Monster Forums - View Single Post

tha5150 · 12.16.2008, 10:59 PM

ok so i am out of town and a bit bored so i will update on my progress.

so far, the front brakes are gone, saved some weight. battery tray is out but no picks yet. the RCM tray should be waiting on me when i get back to town. i have cleaned up all my solder joints and used heat shrink to make it clean. i dont want to mount anything just yet. i came across an issue with mounting the body on. there wasnt enough room to get the back body hole and mount lines up flush. the MMM's wires are sticking up too much. so i can either mount them sideways to the bullets or move the MMM to the opposite side of the motor and behind the battery tray. again, we will see when the tray gets here and how much room i have to play with.

	(#18)
tha5150 RC-Monster Carbon Fiber Offline Posts: 238 Join Date: Mar 2008 Location: delray beach, fl	12.16.2008, 10:59 PM ok so i am out of town and a bit bored so i will update on my progress. so far, the front brakes are gone, saved some weight. battery tray is out but no picks yet. the RCM tray should be waiting on me when i get back to town. i have cleaned up all my solder joints and used heat shrink to make it clean. i dont want to mount anything just yet. i came across an issue with mounting the body on. there wasnt enough room to get the back body hole and mount lines up flush. the MMM's wires are sticking up too much. so i can either mount them sideways to the bullets or move the MMM to the opposite side of the motor and behind the battery tray. again, we will see when the tray gets here and how much room i have to play with.