RC-Monster Forums - View Single Post

10:05 PM

so it finally snows, and i rebuild my emaxx w hv esc w/6.5 motor. when i reprogram the esc, it thinks full finger pull is full reverse. when i flip the throttle channel and reprogram, same results full finger pull is full reverse. i then set it up so, reverse was 25% and i cant seem to get forward movement with a finger pull. if i flip the throttle channel after the program the truck moves and with throttle trim i cant get it to stop
arggggh

any ideas i know this has worked before this is my old setup

also hyperion eos0610i users, what charge cycle do you use and why linear normal automatic?
thanks

	(#1)
e-rev project Guest Posts: n/a	hv 6.5 throttle position - 12.18.2008, 09:13 PM so it finally snows, and i rebuild my emaxx w hv esc w/6.5 motor. when i reprogram the esc, it thinks full finger pull is full reverse. when i flip the throttle channel and reprogram, same results full finger pull is full reverse. i then set it up so, reverse was 25% and i cant seem to get forward movement with a finger pull. if i flip the throttle channel after the program the truck moves and with throttle trim i cant get it to stop arggggh any ideas i know this has worked before this is my old setup also hyperion eos0610i users, what charge cycle do you use and why linear normal automatic? thanks Last edited by e-rev project; 12.18.2008 at 10:05 PM.