RC-Monster Forums - View Single Post - Mini E

RC-Monster Mike · 12:01 PM

I used the rally conversion, an airplane motor(480 size) and made my own chassis, motor mount etc. It uses a mini MG servo, but a full size servo could fit. I drilled new holes in the suspension arms for more travel and used super nitro rally wheels/tires at the time. It would out crawl the tlt, and outhandle the mini ts on the track. It also had plenty of wheelie power(especially with a 3s lipo!) and was a blast to run in the house.
Perhaps I will update this little gem, now that I have some better equipment!
if you take this project on, please post some pictures! I can, of course, help you with parts, etc. as well!
I actually picked up a Feigao 38012l motor to use in this little gem, too. And it eventually got rear 1/10 buggy bowties on chrome rims.

	(#6)
RC-Monster Mike Site Owner Offline Posts: 4,915 Join Date: Nov 2004 Location: PA	11.24.2005, 11:42 AM I used the rally conversion, an airplane motor(480 size) and made my own chassis, motor mount etc. It uses a mini MG servo, but a full size servo could fit. I drilled new holes in the suspension arms for more travel and used super nitro rally wheels/tires at the time. It would out crawl the tlt, and outhandle the mini ts on the track. It also had plenty of wheelie power(especially with a 3s lipo!) and was a blast to run in the house. Perhaps I will update this little gem, now that I have some better equipment! if you take this project on, please post some pictures! I can, of course, help you with parts, etc. as well! I actually picked up a Feigao 38012l motor to use in this little gem, too. And it eventually got rear 1/10 buggy bowties on chrome rims. Last edited by RC-Monster Mike; 11.24.2005 at 12:01 PM.