RC-Monster Forums - View Single Post

Webwiesel · 03:32 PM

Hi need your help

Yesterday my MMM Case opend itself after a bad landing and the red Wire wich goes to the Reciever came loose from the Brainboard. The copper came with it so there is no Solder Point anymore. There are three very small Points left from the conection wich i think comes from the backside of the Brainboard.But it is not enough to make a good soldering. (see attached Pic)

Is somwhere on the upper Brainboard another BEC + Point where i can Solder?
I know my Warranty will be lost and i dont care.
It is an V2 MMM

Best regards and thanks
Webwiesel

Excuse my bad english....

	(#1)
Webwiesel RC-Monster Stock Offline Posts: 13 Join Date: Aug 2008	Need Help from BrianG or a Castle Tech - 01.05.2009, 03:22 PM Hi need your help Yesterday my MMM Case opend itself after a bad landing and the red Wire wich goes to the Reciever came loose from the Brainboard. The copper came with it so there is no Solder Point anymore. There are three very small Points left from the conection wich i think comes from the backside of the Brainboard.But it is not enough to make a good soldering. (see attached Pic) Is somwhere on the upper Brainboard another BEC + Point where i can Solder? I know my Warranty will be lost and i dont care. It is an V2 MMM Best regards and thanks Webwiesel Excuse my bad english.... Attached Thumbnails Last edited by Webwiesel; 01.05.2009 at 03:32 PM.