RC-Monster Forums - View Single Post - Kyosho D series 4wd Center Differntial - Motor Mount

Gee · 01.08.2009, 04:32 AM

Can you get hardened steel Forstner bits for 6 bucks a piece? LOL Made in China? I didn't go the expensice route, but if I thought I would be using it on anything other then platic or wood I would of. Then again it was only 6 bucks so once I get some motor mount templates made using the 18mm then I might give it a try. I can order another one (or better) later on. Is a higher RPM used when drilling in metals?

	(#8)
Gee A Horse's Ass Offline Posts: 1,065 Join Date: Oct 2007 Location: Spokane WA	01.08.2009, 04:32 AM Can you get hardened steel Forstner bits for 6 bucks a piece? LOL Made in China? I didn't go the expensice route, but if I thought I would be using it on anything other then platic or wood I would of. Then again it was only 6 bucks so once I get some motor mount templates made using the 18mm then I might give it a try. I can order another one (or better) later on. Is a higher RPM used when drilling in metals?