RC-Monster Forums - View Single Post

BrianG · 01.13.2009, 06:41 PM

Simply add the motor front end thickness (~4-5mm) and add in the thickness of whatever mount you are using.

Actually, I insert a really long screw into each hole and gently turn the screw in by hand until I feel resistance (the coil). Then, I back out a turn or two and then mark the screw threads where they go into the can. Repeat for the other 3 holes and use the shortest measurement.

	(#4)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	01.13.2009, 06:41 PM Simply add the motor front end thickness (~4-5mm) and add in the thickness of whatever mount you are using. Actually, I insert a really long screw into each hole and gently turn the screw in by hand until I feel resistance (the coil). Then, I back out a turn or two and then mark the screw threads where they go into the can. Repeat for the other 3 holes and use the shortest measurement.