RC-Monster Forums - View Single Post

Shark413 · **Losi 2.0 Conversion -** 01.28.2009, 06:16 PM

Look what showed up today. Still need a body (the one that comes in the box has big holes in it for the nitro stuff) and I have not decided if I am going to use M3 or M4 screws to hold the motor onto the mount. Tapping new threads is not a problem but I noticed on the MMM motor the holes come very close to the endbell screws and there may not be enough meat on the endbell to provide support if I drill and tap for an M4 screw. Got to open up the motor and see what's on the other side of the endbell.

Losi 2.0 race roller, MMM 2650kv combo, Losi E-conversion kit.

	(#1)
Shark413 RC-Monster Carbon Fiber Offline Posts: 468 Join Date: Nov 2006 Location: Los Angeles, CA	Losi 2.0 Conversion - 01.28.2009, 06:16 PM Look what showed up today. Still need a body (the one that comes in the box has big holes in it for the nitro stuff) and I have not decided if I am going to use M3 or M4 screws to hold the motor onto the mount. Tapping new threads is not a problem but I noticed on the MMM motor the holes come very close to the endbell screws and there may not be enough meat on the endbell to provide support if I drill and tap for an M4 screw. Got to open up the motor and see what's on the other side of the endbell. Losi 2.0 race roller, MMM 2650kv combo, Losi E-conversion kit. Losi 2.0 8ight-E / Losi 2.0 8ight-E/T / jammin SCTRC10 / Slash 4x4 PE