RC-Monster Forums - View Single Post

06:24 PM

unfortunately I don't. I just sold it to a member so I can't take one either.
The last pic in my build you can see the brace line straightens up. On the stock plastic brace you need to push out the pivot ball(kind of hard)and with the nuts and bolts in the kit there should of been a black one that fits in. Its small. I'll try to find a better picture.
http://www.rc-monster.com/forum/show...t=17210&page=2

Found one! it should look like this.

	(#6)
Daytona675 Guest Posts: n/a	02.01.2009, 06:12 PM unfortunately I don't. I just sold it to a member so I can't take one either. The last pic in my build you can see the brace line straightens up. On the stock plastic brace you need to push out the pivot ball(kind of hard)and with the nuts and bolts in the kit there should of been a black one that fits in. Its small. I'll try to find a better picture. http://www.rc-monster.com/forum/show...t=17210&page=2 Found one! it should look like this. Last edited by Daytona675; 02.01.2009 at 06:24 PM.