RC-Monster Forums - View Single Post

SpEEdyBL · 02.08.2009, 11:35 PM

Maybe a little late, but here are some facts. I've recorded the rpm of my CC2650 motors and the Novak HV7.5 with and without loads (just the shaft turning and a pinion gear for the 2650 vs. WOT in my 8ight). The 2650 measured in at 2750kv drawing 3.0 amps @ 11.9 volts. On the same voltage the novak motor measured in at 2550 kv drawing 1.7 amps. With the load, the kv was only 100 less for the CC2650 and 200 less for the novak motor.

	(#17)
SpEEdyBL "Out of spec" enthusiast Offline Posts: 820 Join Date: May 2005	02.08.2009, 11:35 PM Maybe a little late, but here are some facts. I've recorded the rpm of my CC2650 motors and the Novak HV7.5 with and without loads (just the shaft turning and a pinion gear for the 2650 vs. WOT in my 8ight). The 2650 measured in at 2750kv drawing 3.0 amps @ 11.9 volts. On the same voltage the novak motor measured in at 2550 kv drawing 1.7 amps. With the load, the kv was only 100 less for the CC2650 and 200 less for the novak motor. Check out my custom converted 8ight: Sub 7lb, lowest CG of any 1/8 buggy http://www.rc-monster.com/forum/show...894#post367894 Area 52 Ranch Raceway T.R.C.R.