RC-Monster Forums - View Single Post - Pass it on... Post a tip or a trick you know about for what ever it is.

BrianG · 02.12.2009, 01:10 AM

The one time I had to remove a pressed pinion, I just clamped the pinion in a vice (I was throwing it away anyway) so the motor is dangling and then used some kind of pin and hammered the shaft. This takes the stress off the shaft and/or bearings.

	(#43)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	02.12.2009, 01:10 AM The one time I had to remove a pressed pinion, I just clamped the pinion in a vice (I was throwing it away anyway) so the motor is dangling and then used some kind of pin and hammered the shaft. This takes the stress off the shaft and/or bearings.