RC-Monster Forums - View Single Post - High kv low gearing VS Low kv high gearing

SpEEdyBL · 05:59 PM

The problem is that people don't READ until they COMPLETELY understand what others have written. My previous posts I know are 100% correct, because I have the formulas AND actual data to back it up.

It could be that the original question is vague. Because if it is refering to two different motors of the same size, but different wind to change the kv, OR two motors of different size to change the kv, there will be two VERY DIFFERENT outcomes. I was refering specifically to motors of the same size, and others seemed to be using facts that would only apply to the bigger motor/smaller motor comparison, which has caused some confusion.

	(#20)
SpEEdyBL "Out of spec" enthusiast Offline Posts: 820 Join Date: May 2005	02.17.2009, 05:23 PM The problem is that people don't READ until they COMPLETELY understand what others have written. My previous posts I know are 100% correct, because I have the formulas AND actual data to back it up. It could be that the original question is vague. Because if it is refering to two different motors of the same size, but different wind to change the kv, OR two motors of different size to change the kv, there will be two VERY DIFFERENT outcomes. I was refering specifically to motors of the same size, and others seemed to be using facts that would only apply to the bigger motor/smaller motor comparison, which has caused some confusion. Check out my custom converted 8ight: Sub 7lb, lowest CG of any 1/8 buggy http://www.rc-monster.com/forum/show...894#post367894 Area 52 Ranch Raceway T.R.C.R. Last edited by SpEEdyBL; 02.17.2009 at 05:59 PM.