RC-Monster Forums - View Single Post - Jato Roller came in planning on putting a remote start on it

Gee · 02.25.2009, 10:09 AM

Here's just a couple of shots of the Jato with the remote start wiring cleaned up. I was able to get the duratrax esc to arm with my Tx. It was smaller then the xl-5 I was using. I also swapped out the sr3100 receiver I was using for the sr3500 (I think that the model #) it's the small version. Got it all to fit into the receivers compartment and center compartment. Looks a lot better with the wires all tucked away. I left the connetion between the ez-start board and the onboard ez-start wire harness. That way I could use a ez-start wand if anything goes haywire with the remote start setup.

Before I cleaned up the wiring.

After the wiring and components were all tucked away.

Thanks for your guys help and support during this project

	(#30)
Gee A Horse's Ass Offline Posts: 1,065 Join Date: Oct 2007 Location: Spokane WA	02.25.2009, 10:09 AM Here's just a couple of shots of the Jato with the remote start wiring cleaned up. I was able to get the duratrax esc to arm with my Tx. It was smaller then the xl-5 I was using. I also swapped out the sr3100 receiver I was using for the sr3500 (I think that the model #) it's the small version. Got it all to fit into the receivers compartment and center compartment. Looks a lot better with the wires all tucked away. I left the connetion between the ez-start board and the onboard ez-start wire harness. That way I could use a ez-start wand if anything goes haywire with the remote start setup. Before I cleaned up the wiring. After the wiring and components were all tucked away. Thanks for your guys help and support during this project