Quote:
Originally Posted by Gee
Thanks guys....... To me the use of a micro servo to contact the start button would have been more difficult then the use of an esc. The location of the micro servo and the ez-start would of been difficult to do. At least that the way I see it on this setup. The esc regulates the power to the receiver. This method seems like a lot but it wasn't that much. To simply state why not use a micro servo makes it seem like that would of been much simpler until you try to locate the servo, sercure it and the ez-start board down to where they make contact........
Why not simply use an esc to power the ez-start from the 3rd channel on your receiver.
|
It looks cool and works fine - apologies if it came across as a flame... Quite a few crawlers use a switch/micro servo combo for dig setups which is what I had seen. I thought that would have been easier than an esc but from the video it is working really wel..