[jzemaxx]

Ok guys something I didn't think about and maybe some of the big brains can answer this. The HW150 automatically is set to 15 deg of timing. Now the question is, could this cause a problem with a Neu/CC motor. I know its a 4 pole vs HW 3674 2 pole motor. Do I need to maybe try lower timing on the NEU/CC to see if it picks up speed?? I read that the 4 poles like low timing versus high timing. 15 deg is quite a bit and didn't think of that. I just set both controllers to 15 deg since the HW was already set to that.