RC-Monster Forums - View Single Post - Brushless TTR ST-1

jsr · **Brushless TTR ST-1 -** 03.12.2009, 01:22 AM

I had the ST-1 for 7 months before I converted it. I actually had almost all the brushless parts already, but didn't have a motor mount. I sent Mike my center diff assembly which he used to prototype the mount now available on his site. The mount came a bit different from what I expected. I planned on the motor to be mounted on the opposite side so I needed to rearrange my initial planned layout, but no biggy. My setup's changed a bit since that shown in the pic. I run a different spring in the rear (Reckward Tuning Extra Hard Progressive springs) and 4s LiPos.

My setup is as follows:

CC Mamba Max ESC
Turnigy UBEC 6V/3A
KD36 -74-06XL 2800kv BL motor

I'm going to be changing the motor to a Hobbywing EZRun SL3674 2350kV and see how that runs on both 4s and 3s.

	(#1)
jsr RC-Monster Carbon Fiber Offline Posts: 212 Join Date: Feb 2009	Brushless TTR ST-1 - 03.12.2009, 01:22 AM I had the ST-1 for 7 months before I converted it. I actually had almost all the brushless parts already, but didn't have a motor mount. I sent Mike my center diff assembly which he used to prototype the mount now available on his site. The mount came a bit different from what I expected. I planned on the motor to be mounted on the opposite side so I needed to rearrange my initial planned layout, but no biggy. My setup's changed a bit since that shown in the pic. I run a different spring in the rear (Reckward Tuning Extra Hard Progressive springs) and 4s LiPos. My setup is as follows: CC Mamba Max ESC Turnigy UBEC 6V/3A KD36 -74-06XL 2800kv BL motor I'm going to be changing the motor to a Hobbywing EZRun SL3674 2350kV and see how that runs on both 4s and 3s.