[YogyBrushless]

thanks for the info, the setscrew seems to have a snug fit but i also toke the advice and a grinded the setscrew a little more to have more bite area and i found out it had very little to begin with (it was concave to the in inside) hope this helps. i`m gone work more on having a flatter area on the shaft ( seems to have a little slope in it).

as for the heat i think my throttle curve making the clutch shoes drag a little longer, than they should do so that creating more heat. i drove around with for a couple of minutes and after a stopped for another 2-3 mins the clutch bell was at 110f so i`m guessing that's too hot, i will replace the clutch shoes with new MIP ones ( hopefully better bite less drag) i`ll work on it some more and keep u guys posted i hope before i leave the country tomorrow (one week business trip)

Yousef