RC-Monster Forums - View Single Post

magman · 10:30 PM

My daughter's crt.5

1. mm esc
2. Medusa 50 series 3300kv 5mm shaft
3. TrueRc hard case 2s li-po 5000mah
4. Futaba 125 oz servo
5. Pro line 2.2 Gladiator tires
6. Slingshot white rums/dyed black

ESC settings:

1. timing 2 deg.
2. med start power
3. 30% punch control
4. 60% brakes
5. 3.2 v/c li-po cut off

stock spur..44 I think ....16 pinion

Temps have greatly depended on her driving and where we drive. Sunday she kept thermaling the esc...we were in beach sand which I am sure was 80% of the issue. I have since tweaked the esc a bit...so we shall see.

All in all the esc /motor combo is smooth and plenty for her

	(#25)
magman RC-Monster Dual Brushless Offline Posts: 4,236 Join Date: Dec 2007 Location: Cape Cod, Mass.	03.12.2009, 09:41 PM My daughter's crt.5 1. mm esc 2. Medusa 50 series 3300kv 5mm shaft 3. TrueRc hard case 2s li-po 5000mah 4. Futaba 125 oz servo 5. Pro line 2.2 Gladiator tires 6. Slingshot white rums/dyed black ESC settings: 1. timing 2 deg. 2. med start power 3. 30% punch control 4. 60% brakes 5. 3.2 v/c li-po cut off stock spur..44 I think ....16 pinion Temps have greatly depended on her driving and where we drive. Sunday she kept thermaling the esc...we were in beach sand which I am sure was 80% of the issue. I have since tweaked the esc a bit...so we shall see. All in all the esc /motor combo is smooth and plenty for her 1. MBX-6 T8 1900KV, RX8 ON 4S 2. MBX-5T 1520, MMM ON 5S 3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S 4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S 5. TEN T 2650 T8, MMP ON 3S Last edited by magman; 03.12.2009 at 10:30 PM.