Finally found some time inbetween other jobs to make myself something. I managed to get a cheap LSP of the bay so its time for some custom.
£60 motor, another bargain, its a Neu 1515
start of the motor mount
2 hours later....
quite proud of myself, I managed to cut the bearing hole on my rotary table and its a nice tight fit.
Im having the "center" diff at the back, I was thinging i'd have a really short rear prop shaft, but then decided to change the diff outdrive for a dogbone end and fit it direct to the rear diff. I turned a bit or steel down and bashed a couple of pins through, nice!
plastic spur.
