RC-Monster Forums - View Single Post - Various Baja 5b questions and a possible new project

What's_nitro? · 01:21 AM

I did actually. I set the Texp low on the radio and it helped a lot. The MMM (V2) still had trouble even after I played around with the settings. IDK why. I put the MMM in there because the Sentilon was still a bit jittery on take off. This was with the 30/40 gears. I replaced them with 20/51 gears for "normal" driving and the Sentilon would light up all four tires on command, as would the MMM.

The SC data looks fine. You do have tire ballooning at 0, but that only affects the top end. Can you get any smaller pinions if you need to? Or do the 1521's have an 8mm shaft...? I hope you can pull it off... It will definitely out-perform the gas version. With two motors it will (still) weigh less, but have twice as much power!

	(#8)
What's_nitro? Soldermaster Extraordinaire Offline Posts: 4,529 Join Date: Apr 2007 Location: Plymouth, MA, USA	03.18.2009, 01:12 AM I did actually. I set the Texp low on the radio and it helped a lot. The MMM (V2) still had trouble even after I played around with the settings. IDK why. I put the MMM in there because the Sentilon was still a bit jittery on take off. This was with the 30/40 gears. I replaced them with 20/51 gears for "normal" driving and the Sentilon would light up all four tires on command, as would the MMM. The SC data looks fine. You do have tire ballooning at 0, but that only affects the top end. Can you get any smaller pinions if you need to? Or do the 1521's have an 8mm shaft...? I hope you can pull it off... It will definitely out-perform the gas version. With two motors it will (still) weigh less, but have twice as much power! Last edited by What's_nitro?; 03.18.2009 at 01:21 AM.