RC-Monster Forums - View Single Post

BrianG · 03.18.2009, 03:19 PM

I'd check all your motor connections. This includes the bullet connectors (could be dirty), the bullet solder connections, the battery plug (cold solder joint and/or dirty contacts, and the solder connections where the wires meet the ESC.

If that's not it, you might have weakened/damaged some of the FETs. My setup (3s on the 3300) in the CRT.5 runs prefectly fine with no cogging at all.

	(#2)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	03.18.2009, 03:19 PM I'd check all your motor connections. This includes the bullet connectors (could be dirty), the bullet solder connections, the battery plug (cold solder joint and/or dirty contacts, and the solder connections where the wires meet the ESC. If that's not it, you might have weakened/damaged some of the FETs. My setup (3s on the 3300) in the CRT.5 runs prefectly fine with no cogging at all.