[E-Revonut]

Originally Posted by e-mike

dont worries guy's i know that medusa made great motor..of sure there are not a lot of failure like that reported about the 70 mm can...so my motor is in the way....to medusa compagnie i was just frustrated because in 2 days my mmmv3 went up in flame and the next day the magnet of my new motor come off of the shaft.....im just unlucky

Unlucky? I don't think luck is part of the equasion. I think you might be asking to much of your truck/setup. Just because a motor is capable of being spun at 50K doesn't mean that you should. a lot of that rating comes from the bearing's capabilities. Magnets are a natural material and although we machine them into different shapes that doesn't always get rid of mother nature's inconsistincies. I highly recomend getting a lower kv motor for 6s! I ran my 1515 2.5d on 6s twice and it was too much to control, I have found 5s to be a better setup. While your motor is down send your packs to link and have some 5s setups made or 4s if you want to stick with the 2000+kv motors