after its madin voyage, I have mixed fealings...
the pinion is a PIA to get on and stay on, I hope grinding a flat spot on the shaft solves this...
the esc gets a little hotter that I would like, 6(i think) LEDs after a 15min run, but yet the case wasn't hot to the toch and the hotest temp I got was 165 off of the solder posts. any sujestions on colling it down??
COGING!!!!
its only a little going forward, but I can't back up at all, it just stutters
OMFG I have POWER!!!!
its at the track right now, so I'll get pics tomarow, but I realy like the way I layed it out
still sounds like a chainsaw...
