RC-Monster Forums - View Single Post

KaztheMinotaur · 03.22.2009, 07:08 AM

No there is nothing on the endbell to keep the bearing in place. I have 2 extra flanged bearings but the OD is bigger than the OD on the non-flanged. I could dremel the hole in the end bell I suppose. The shaft side uses a flanged but the endbell side does not.

Is green locktite heat resistant? I was thinking of smearing some red around the outside of the bearing before I put it back in.

	(#4)
KaztheMinotaur RC-Monster Carbon Fiber Offline Posts: 351 Join Date: Dec 2007 Location: Central PA	03.22.2009, 07:08 AM No there is nothing on the endbell to keep the bearing in place. I have 2 extra flanged bearings but the OD is bigger than the OD on the non-flanged. I could dremel the hole in the end bell I suppose. The shaft side uses a flanged but the endbell side does not. Is green locktite heat resistant? I was thinking of smearing some red around the outside of the bearing before I put it back in.