RC-Monster Forums - View Single Post

Joey · 03.30.2009, 09:00 PM

Well i went back to the senior design workshop and found the perfect sheet of aluminum for an esc plate. The holes are EXACTLY the right size for an M4 screw and were in the EXACTLY perfect spot to line up with the holes already in the chassis for the GP motor mount braces. So I snipped it up to size and here is what I have for an esc mount now. Notice it leaves just enough space for the motor to clear the top of it. Man I lucked out on this one!

	(#50)
Joey The Big Cheese Offline Posts: 125 Join Date: Mar 2009 Location: Georgia, USA	03.30.2009, 09:00 PM Well i went back to the senior design workshop and found the perfect sheet of aluminum for an esc plate. The holes are EXACTLY the right size for an M4 screw and were in the EXACTLY perfect spot to line up with the holes already in the chassis for the GP motor mount braces. So I snipped it up to size and here is what I have for an esc mount now. Notice it leaves just enough space for the motor to clear the top of it. Man I lucked out on this one!