RC-Monster Forums - View Single Post

Finnster · 04.04.2009, 05:48 PM

Did I mention the part where I'm a cheap bastard and don't want to buy a $$$ 1521? lol
That would be the top of my list, but I really don't want to pay over $150 for a motor. If the flux uses the 1515 1y w/ success, I would think the 1515 3D would do fine at the power levels I'm looking for.

All the other options require getting/making a motor mount. W. the tekno the way it is I just need to cut some holes in the motor plate for 4mm bolts. Then it would slide easily for EZ meshing. I know the medusas are quality, but the neus are a bit higher and I'm not sure its worth dropping that bit in quality for a bit more TQ. The low kv motors have so much more TQ already, I don't want to be a backflip machine. That was one of the nice things about the nitro motor, a lot more controllable w/ that weak bottom end!

	(#11)
Finnster KillaHurtz Offline Posts: 2,958 Join Date: Apr 2006 Location: Bucks Co, PA	04.04.2009, 05:48 PM Did I mention the part where I'm a cheap bastard and don't want to buy a $$$ 1521? lol That would be the top of my list, but I really don't want to pay over $150 for a motor. If the flux uses the 1515 1y w/ success, I would think the 1515 3D would do fine at the power levels I'm looking for. All the other options require getting/making a motor mount. W. the tekno the way it is I just need to cut some holes in the motor plate for 4mm bolts. Then it would slide easily for EZ meshing. I know the medusas are quality, but the neus are a bit higher and I'm not sure its worth dropping that bit in quality for a bit more TQ. The low kv motors have so much more TQ already, I don't want to be a backflip machine. That was one of the nice things about the nitro motor, a lot more controllable w/ that weak bottom end!