RC-Monster Forums - View Single Post - Looking for a diff cup w/a 6mm bore and accepts a .304 ball end

magman

I am using the 3095 trans w/the new revo v3 diffs... The cup sizes are different, traxxas vs the one that comes wMike's kit. So...In order to run dogbones in then cedter I need a new diffcup w/a bore of 6mm for the Trans. end and it must accept a ball end of .304"

I looked on tower, but, they don't give me enough specs. to be 100% sure. The only thing I thought of doing is getting a mugen diff cup and have it bored out to fit on the traxxas shaft

	(#1)
magman RC-Monster Dual Brushless Offline Posts: 4,236 Join Date: Dec 2007 Location: Cape Cod, Mass.	Looking for a diff cup w/a 6mm bore and accepts a .304 ball end - 04.15.2009, 12:29 PM I am using the 3095 trans w/the new revo v3 diffs... The cup sizes are different, traxxas vs the one that comes wMike's kit. So...In order to run dogbones in then cedter I need a new diffcup w/a bore of 6mm for the Trans. end and it must accept a ball end of .304" I looked on tower, but, they don't give me enough specs. to be 100% sure. The only thing I thought of doing is getting a mugen diff cup and have it bored out to fit on the traxxas shaft 1. MBX-6 T8 1900KV, RX8 ON 4S 2. MBX-5T 1520, MMM ON 5S 3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S 4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S 5. TEN T 2650 T8, MMP ON 3S