RC-Monster Forums - View Single Post - Brushless Lightning Stadium Pro conversion

Joey · 04.17.2009, 03:18 AM

Ok so... the mill (drill press?) is on the left and lathe on the right? Im still confused, if you clamp the alu down in a vice, what do you move across it to make the long cuts? Or do you clamp it to part of the mill that can slide, and use a special drill bit to slide the alu against to make the cut?

Sorry for the questions, Ive just always wondered about this.

	(#93)
Joey The Big Cheese Offline Posts: 125 Join Date: Mar 2009 Location: Georgia, USA	04.17.2009, 03:18 AM Ok so... the mill (drill press?) is on the left and lathe on the right? Im still confused, if you clamp the alu down in a vice, what do you move across it to make the long cuts? Or do you clamp it to part of the mill that can slide, and use a special drill bit to slide the alu against to make the cut? Sorry for the questions, Ive just always wondered about this.