RC-Monster Forums - View Single Post - Brushless Lightning Stadium Pro conversion

_paralyzed_ · 03:30 AM

if you look at the vise on the mill bench (the machine on the left) you can see there are handles to either screw it in or out straight or left to right. The bits are designed to cut sideways, rather than straight down. So you set the bit and then turn the handles until you have the desired cut.

edit: the handles are part of the mill bench, the vise is mounted atop that

	(#94)
_paralyzed_ working on a brushless for my wheelchair..... Offline Posts: 4,890 Join Date: Mar 2007 Location: minnesnowta	04.17.2009, 03:28 AM if you look at the vise on the mill bench (the machine on the left) you can see there are handles to either screw it in or out straight or left to right. The bits are designed to cut sideways, rather than straight down. So you set the bit and then turn the handles until you have the desired cut. edit: the handles are part of the mill bench, the vise is mounted atop that _______________________________________ It's "Dr. _paralyzed_" actually. Not like with a PhD, but Doctor like in Dr. Pepper. Last edited by _paralyzed_; 04.17.2009 at 03:30 AM.