RC-Monster Forums - View Single Post - Want to buy RCM V3 Hybrids, what to use for center shafts?

doo540 · 04.22.2009, 08:56 PM

Shizzon reread post #8.
You can use the rear e-revo shaft from KD BUT you are going to need the 3905 (emaxx) front steel shaft. The e-revo front steel drive shaft is to long. Trust me I tried it.
My v3 are doing great. I also have a e-revo that is running the Losi LST2 diffs and that is a strong setup too. I've been beating on the V3 and they are holding up.
Shizzon I would think that Dan would exchange shafts for you if you email him. If not I will take that front steel shafts off your hands for you.

	(#15)
doo540 RC-Monster Carbon Fiber Offline Posts: 310 Join Date: Jul 2008	04.22.2009, 08:56 PM Shizzon reread post #8. You can use the rear e-revo shaft from KD BUT you are going to need the 3905 (emaxx) front steel shaft. The e-revo front steel drive shaft is to long. Trust me I tried it. My v3 are doing great. I also have a e-revo that is running the Losi LST2 diffs and that is a strong setup too. I've been beating on the V3 and they are holding up. Shizzon I would think that Dan would exchange shafts for you if you email him. If not I will take that front steel shafts off your hands for you.