My custom maxx is going to a friend. it was a tough decision as the truck got me into RC, but sice i started to race i have so many cars to take care of and not enough time tu run it. I probably tried everything there is to make my maxx completely bullet proof basher.
I am keeping all the electronics and it's going to my BCE MBX5-T as it is just too much work racing both nitro truggy and buggy. And buggies are more fun as there is much more competition.
Since Tekin RX8 is still not available - want to use 1700kv truggy combo. i will use Neu 1512 2050kv with MGM until i get hold of tekin.
With 46/12 gearing it should work ok as total gear reduction will be 17.63:1 and on my maxx i had 18:1 and neu had no issues to move it around when maxx was over 13lbs.
Mugen should be under 10lbs RTR with 5S lipo
Truck will have mbx5 buggy 2mm offset hubs as with standard truggy hubs it's just too wide for some technical tracks (over 1/2" wider than losit 8ight-t)
I got MBX6 shocks (they work incredibly well) on my mugen so it should do ok this racing season.
Slipperential will arrive on monday and once i got it I will put here few pictures as right now it's just a roller with only servo installed.