RC-Monster Forums - View Single Post - CEN Racing Differential Parts List for Savage FYI

Gee · 07:19 PM

Thanks. Still checking out all the options. Do you think the ring gear from the cen would fit right onto the xl cup? Just swap out the xl ring gear and 13t bevel gear for those on the cen?

I was doing some research on my above question and found a thread at savage central were a guy has been testing this in his flux. Sounds like it is holding up pretty good. Here's the link:

http://www.savage-central.com/module...&highlight=cen

I order the cen ring and bevel gears to give it a shot myself. Unfortunately I had to order them from two different places. So I got double dinged on the shipping cost. I got the two ring gears for 30.00 and the two bevel gears for 23.00. That's the cost w/o the shipping inlcuded.

Just a FYI for anyone interested. I was also looking around for a 13t beveled pinion that might hold up better then the HPI 13t does. Attached is the document with a list of possibilities. I haven't followed up on it much after I found out about the above possibility.

13t bevel gear comp.doc

Still waiting on a couple of responses on the length of the overall pinion itself.

	(#13)
Gee A Horse's Ass Offline Posts: 1,065 Join Date: Oct 2007 Location: Spokane WA	04.30.2009, 04:17 PM Thanks. Still checking out all the options. Do you think the ring gear from the cen would fit right onto the xl cup? Just swap out the xl ring gear and 13t bevel gear for those on the cen? I was doing some research on my above question and found a thread at savage central were a guy has been testing this in his flux. Sounds like it is holding up pretty good. Here's the link: http://www.savage-central.com/module...&highlight=cen I order the cen ring and bevel gears to give it a shot myself. Unfortunately I had to order them from two different places. So I got double dinged on the shipping cost. I got the two ring gears for 30.00 and the two bevel gears for 23.00. That's the cost w/o the shipping inlcuded. Just a FYI for anyone interested. I was also looking around for a 13t beveled pinion that might hold up better then the HPI 13t does. Attached is the document with a list of possibilities. I haven't followed up on it much after I found out about the above possibility. 13t bevel gear comp.doc Still waiting on a couple of responses on the length of the overall pinion itself. Last edited by Gee; 04.30.2009 at 07:19 PM.