RC-Monster Forums - View Single Post

BrianG · 05.04.2009, 10:56 AM

Yup, same or very similar gauge wire is needed. There is a coating on the receiver board though that needs to be removed. Just scrape around that area and then solder, otherwise it can get a bit messy. And since this board is so small, try not to keep too much heat on it for too long.

	(#9)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	05.04.2009, 10:56 AM Yup, same or very similar gauge wire is needed. There is a coating on the receiver board though that needs to be removed. Just scrape around that area and then solder, otherwise it can get a bit messy. And since this board is so small, try not to keep too much heat on it for too long.