I am trying to figure out where the best place would be to mount my receiver on my Maxx. With the motor up front and in the middle, I was thinking of mounting it next to the motor opposite the steering servo. The motor wires are above the servo. Now with this setup, will I get alot of interference? And yes it is the stock TQ3 AM 27Mhz tx/rx, but I will probably be swapping in my JR XR2i Tx and Rx in a few days, which is still AM but its on the higher 75 MHz AM band. But even with the JR 75 MHz AM Rx, in that location will I still get alot of interference since it's right next to the motor?
Here is a picture -
(And yes I know it's covered in dirt.)
Thanks for any help.