RC-Monster Forums - View Single Post - Received my 9920/8xl and ib3800's today

Re~Mix · 12.22.2005, 01:06 PM

The flat spot on the motor shaft really isn't necessary, just crank it down with a hex driver and you should be good. As far as an opening on the back of the motor, I usually just cover it up with electrical tape around the wires.

For the front i'm not sure what you should do though. They all seem like reasonable solutions

	(#2)
Re~Mix ¡Go Baby Go! Offline Posts: 361 Join Date: Apr 2005 Location: Minnesota	12.22.2005, 01:06 PM The flat spot on the motor shaft really isn't necessary, just crank it down with a hex driver and you should be good. As far as an opening on the back of the motor, I usually just cover it up with electrical tape around the wires. For the front i'm not sure what you should do though. They all seem like reasonable solutions RC18T FT - Quark Castle Creations Airtronics IB