RC-Monster Forums - View Single Post

BrianG · 05.17.2009, 11:28 AM

Yeah, I personally wouldn't parallel BECs at all. It depends on the design of the BEC circuit really. I've had a BEC (can't remember which) get really hot if the output was fed with even a slightly higher voltage.

If you have a high servo load, I would just run a seperate BEC on just that device. It's just a matter of isolating the red wire, but the ground and signal wires need to be directly paralleled.

	(#5)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	05.17.2009, 11:28 AM Yeah, I personally wouldn't parallel BECs at all. It depends on the design of the BEC circuit really. I've had a BEC (can't remember which) get really hot if the output was fed with even a slightly higher voltage. If you have a high servo load, I would just run a seperate BEC on just that device. It's just a matter of isolating the red wire, but the ground and signal wires need to be directly paralleled.