RC-Monster Forums - View Single Post - Please make a small can (2650 size) 2000-2200 kv motor

SpEEdyBL · 05.30.2009, 03:38 PM

I think Patrick said Y winds only not "1Y only," the reason being that the magnet would be optimized for the Y wind instead of a compromise of both Y and D like the neus. A 1.5Y 1512 sized motor would be 1900 kv just like the tekin T8 4030 1.5Y, so I can't see why that can't be done. That would be perfect on 6s bashing, and 4s/5s racing, better than a 1y on 4s and 3s. I already consistantly get the mmm fan on in less than 5 minutes with my driving. I'm guessing there is some sort of delay anyway since I haven't even heard of any updates of the 1800 and 1500 kv long can motors for quite some time. I would expect a low kv short can motor to be a ways off.

	(#1)
SpEEdyBL "Out of spec" enthusiast Offline Posts: 820 Join Date: May 2005	05.30.2009, 03:38 PM I think Patrick said Y winds only not "1Y only," the reason being that the magnet would be optimized for the Y wind instead of a compromise of both Y and D like the neus. A 1.5Y 1512 sized motor would be 1900 kv just like the tekin T8 4030 1.5Y, so I can't see why that can't be done. That would be perfect on 6s bashing, and 4s/5s racing, better than a 1y on 4s and 3s. I already consistantly get the mmm fan on in less than 5 minutes with my driving. I'm guessing there is some sort of delay anyway since I haven't even heard of any updates of the 1800 and 1500 kv long can motors for quite some time. I would expect a low kv short can motor to be a ways off. Check out my custom converted 8ight: Sub 7lb, lowest CG of any 1/8 buggy http://www.rc-monster.com/forum/show...894#post367894 Area 52 Ranch Raceway T.R.C.R.