RC-Monster Forums - View Single Post

JOHNNYMAXXIMA · 12.27.2005, 06:35 AM

I don't believe either. I think it is because the arm popped out of the hinge pin is what is making it look bent as you can see in the pic below. I will know more when I start to take it apart over the next few days.
Also, it's kinda hard to tell from this pic, but the front titanium skid got bent as well. I'd say about a good 4-5mm bent.
Thanks.

	(#25)
JOHNNYMAXXIMA RC-Monster Dual Brushless! Offline Posts: 950 Join Date: Feb 2005 Location: Corona, Ca.	12.27.2005, 06:35 AM I don't believe either. I think it is because the arm popped out of the hinge pin is what is making it look bent as you can see in the pic below. I will know more when I start to take it apart over the next few days. Also, it's kinda hard to tell from this pic, but the front titanium skid got bent as well. I'd say about a good 4-5mm bent. Thanks. Attached Thumbnails