RC-Monster Forums - View Single Post

Metallover · 11:45 PM

I just made an offer on a used tc3. $110 shipped. I hope I get it. It's rtr with a 11t brushed motor.

If I get it, I'll have to start thinking about electronics. I could probably borrow my mamba max from the revo. Now I just need the biggest motor that will fit that runs good on 4s.

Turnigy 36-56-2600 5mm shaft - http://www.hobbycity.com/hobbycity/s...600kv_Inrunner

KD 36-60-3000 5mm shaft - http://www.hobbycity.com/hobbycity/s...hless_Inrunner

I want to use a 3.2mm shafted motor as I have lots of pinions that size I want to use. Is it too risky to grind the shaft down to 3.2mm?

	(#18)
Metallover RC-Monster Spudgunner Offline Posts: 2,353 Join Date: Apr 2008 Location: South Dakota	06.03.2009, 11:43 PM I just made an offer on a used tc3. $110 shipped. I hope I get it. It's rtr with a 11t brushed motor. If I get it, I'll have to start thinking about electronics. I could probably borrow my mamba max from the revo. Now I just need the biggest motor that will fit that runs good on 4s. Turnigy 36-56-2600 5mm shaft - http://www.hobbycity.com/hobbycity/s...600kv_Inrunner KD 36-60-3000 5mm shaft - http://www.hobbycity.com/hobbycity/s...hless_Inrunner I want to use a 3.2mm shafted motor as I have lots of pinions that size I want to use. Is it too risky to grind the shaft down to 3.2mm? Last edited by Metallover; 06.03.2009 at 11:45 PM.