RC-Monster Forums - View Single Post - MMM V2 collateral damage

BrianG · 06.06.2009, 01:26 AM

The things that would typically go bad in a servo are voltage sensitive devices: the "decoder" IC and a few transistors/FETs for the motor driver. But that's about 75% of the servo. The rest is the case, motor, gears, and feedback pot. I doubt there is a fuse in there, and even if there was, fuses are for overcurrent protection, not overvoltage.

	(#2)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	06.06.2009, 01:26 AM The things that would typically go bad in a servo are voltage sensitive devices: the "decoder" IC and a few transistors/FETs for the motor driver. But that's about 75% of the servo. The rest is the case, motor, gears, and feedback pot. I doubt there is a fuse in there, and even if there was, fuses are for overcurrent protection, not overvoltage.