RC-Monster Forums - View Single Post

NovakTwo · 06.09.2009, 10:33 AM

We separate the shafts from the magnets by putting the rotors in one of our ovens at extremely high heat.

This heats the epoxy until the shaft can be pulled out.

	(#10)
NovakTwo Senior Strategist Offline Posts: 383 Join Date: May 2007	06.09.2009, 10:33 AM We separate the shafts from the magnets by putting the rotors in one of our ovens at extremely high heat. This heats the epoxy until the shaft can be pulled out. Novak Electronics, Inc.