|
06.11.2009, 03:22 AM
Pretty sure linc is right on this one - basically it's just a matter of creating a tighter fit between the piston and sleeve to increase the friction (and thus compression) between the two. Cheaper than a rebuild so it saves money, and you can vary the level of "pinch" as a way of controlling how tight an engine runs.
SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
|