Got the scale lighting system from RC4WD today.


Then I decided I HAD to try it out so I through some Slash electronics on it for now. Tried putting the slash motor on the r2d and the hole in the r2d wasnt big enough. Figure it was time to break out the dremel and go to town. Took it all apart dremeled it out went outside and washed all the shaving out with some soapy water and blew it off with the air hose. Put it all back together and see if it wokred by just hooking a battery straight to the motor and one of the pins for the gears came clean out the side. Got to looking on one of the little brass bushing that holds the pin in fell out. OHHH MAN. That sucks. So I went on a scavenger hunt and after about 3 minutes I smoehow found it laying in the grass beside the garden hose. lol Lucky me.


Had to make another dig servo mount cause I didnt leave room for the motor. oops.


The electronics arnt in the final spot for now. This is jsut for testing. Going to move the esc and receiver later on.


Random pic.


Test vids coming soon.