RC-Monster Forums - View Single Post - Brushless hpi baja rc-monster

nitrostarter · 06.15.2009, 11:13 AM

Ah! I see sir. I have my 1521 from boating and they use the 8mm shafts. Thanks for the answer, and you can ignore that email I sent as well.

My follow-up question is do you think there is enough material there to have the 5mm pinions drilled out to 8mm and them still be strong enough?

Thanks Mike!

I may have to get that collet from TDR and bore it to 8mm, and then run you screw on pinions.

	(#71)
nitrostarter RC-Monster Brushless Offline Posts: 3,156 Join Date: Jul 2005 Location: Gramercy, LA	06.15.2009, 11:13 AM Ah! I see sir. I have my 1521 from boating and they use the 8mm shafts. Thanks for the answer, and you can ignore that email I sent as well. My follow-up question is do you think there is enough material there to have the 5mm pinions drilled out to 8mm and them still be strong enough? Thanks Mike! I may have to get that collet from TDR and bore it to 8mm, and then run you screw on pinions. N. Rustler conversion