[suicideneil]

MM Pro is shaping up to be a do-it-all esc for anything from a 1/12 to a 1/8 scale, which is nice (any Fastshow fans out there? no? just me then...).

To address someones requests earlier though;

1. The one-touch programming of my orange esc was very nice, and very simple, I must admit, would be worth concidering atleast.
3. Like the HW escs, would be nice and shouldnt be too hard to do- just means soldering on a laid down 2 pin and 3 pin connectors that stick out the side or top of the esc. No more ripped off switches or damaged rx leads that cant be easily replaced by the user- just think of the repairs that would save if you could buy them seperately to replace a damaged one...