sorry guys - ain't gonna work -lol-

First, i tried raising the servo by using the LOWER TABS in the servo..... and then i took the servo arm off, turned it 180 degrees (as if it was to spin 180 degrees - so the arm now faces down - like batfish drew out) and put it back on...

which would have worked quite well, exept for the fact that the tranny mount is in the way of the servo arm's movement...
i can't shave any material on the tranny mount - or it will be down to the screw holding it there.

The actual output gear on the servo - needs to be on the side that it is on in the pics on pg 1 - the motor wires are in the way there....

The easiest thing for me to do is grab one of those servo reversing leads i think - i'm not one for modifications really -lol-