RC-Monster Forums - View Single Post

BrianG · 06.30.2009, 09:10 PM

Any 6s+ controllers in the works with motor kvs to match?

Also, this is more of a design question, but it seems the current HV series stuff is designed to run at high rpms. Is there a particular reason for that decision? Being sensored, I would think that lower rpms would be just fine, and there would be less strain on parts (bearings, rotor, etc) if it was spinning at the typical 35-40k rpm range. Not knocking your stuff or anything, just curious.

	(#12)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	06.30.2009, 09:10 PM Any 6s+ controllers in the works with motor kvs to match? Also, this is more of a design question, but it seems the current HV series stuff is designed to run at high rpms. Is there a particular reason for that decision? Being sensored, I would think that lower rpms would be just fine, and there would be less strain on parts (bearings, rotor, etc) if it was spinning at the typical 35-40k rpm range. Not knocking your stuff or anything, just curious.